What size prints do I need?
Approximately the size of a A4 Sheet of paper possibly more. I tried to get away from the small printers as quickly as possible. Though that its not going to be plug and play was kinda clear. Calibration seems to be the main topic quite a lot of times.
10l? Sounds amazing!
I try to go as big as I dare for now, as I am not able to calculate eventual swinging of beams and such, thus creating inaccuracies which are not necessary.
At this point, its gonna be a Delta. Worst case scenario includes mostly the same electronics in another projects, while I figure out what I did wrong with attempt one.
Approximately the size of a A4 Sheet of paper possibly more. I tried to get away from the small printers as quickly as possible. Though that its not going to be plug and play was kinda clear. Calibration seems to be the main topic quite a lot of times.
10l? Sounds amazing!
I try to go as big as I dare for now, as I am not able to calculate eventual swinging of beams and such, thus creating inaccuracies which are not necessary.
At this point, its gonna be a Delta. Worst case scenario includes mostly the same electronics in another projects, while I figure out what I did wrong with attempt one.