Next question please.
As you have printed 3DR_Bottom_Motor_Mount_V2_001_RTP.stl you hadn t any problem with the alu extrusion. It did fit ?
If yes, which PLA did you use? I am fighting since one week, but with no success...it does not fit and I don t know if it is the slicer or the PLA material I am using.
The witdth of the printed T-Slot I get is at least 6.50 mm but on the STL it is ca. 5.60.
Thanks!
As you have printed 3DR_Bottom_Motor_Mount_V2_001_RTP.stl you hadn t any problem with the alu extrusion. It did fit ?
If yes, which PLA did you use? I am fighting since one week, but with no success...it does not fit and I don t know if it is the slicer or the PLA material I am using.
The witdth of the printed T-Slot I get is at least 6.50 mm but on the STL it is ca. 5.60.
Thanks!