How would the dynamics of supporting this machine change if the entire machine were suspended or bolted to the underside of a desk/cabinet? Maybe this is the perfect design for taking a 3' media cabinet and stacking two of these on top of eachother inside.
I have one of these MDF media cabinets that I have been thinking of converting to an enclosed printer:
[www.amazon.com]
I was thinking of a design where the steppers are outside of/on top of cabinet and it is full-height, or two units, maybe with the bottom unit having steppers underneath/outside of the cabinet. Just cut a circular hole in the bottom probably.
But it's easy to find others anywhere ..
[www.amazon.com]
[www.amazon.com]
I have one of these MDF media cabinets that I have been thinking of converting to an enclosed printer:
[www.amazon.com]
I was thinking of a design where the steppers are outside of/on top of cabinet and it is full-height, or two units, maybe with the bottom unit having steppers underneath/outside of the cabinet. Just cut a circular hole in the bottom probably.
But it's easy to find others anywhere ..
[www.amazon.com]
[www.amazon.com]