@Dannydefe: 2.54mm per turn is not enough. For most steppers and drivers this will top you out at 25.4mm/s. I think the top speed should at least break 50mm/s. For $60 you can get 25.4mm per turn. I am also considering buying some lead nuts from Roton to keep me from printing them. They are only $10. [www.roton.com]
That brings the total to around $90 but that isn't much compared to all the other hardware we save on.
That brings the total to around $90 but that isn't much compared to all the other hardware we save on.