Neat design.
So how many tons of tension will be necessary to straighten the leadscrews?
Are there thrust bearings or taper bearings at top and bottom?
This requires tension or very straight leadscrews?
Do they tension leadscrews at the factory to straighten them?
I don't understand how the nuts and fixtures on the leadscrew are prevented from rotation?
Does the geometry of the center spider make it manageable?
:S
So how many tons of tension will be necessary to straighten the leadscrews?
Are there thrust bearings or taper bearings at top and bottom?
This requires tension or very straight leadscrews?
Do they tension leadscrews at the factory to straighten them?
I don't understand how the nuts and fixtures on the leadscrew are prevented from rotation?
Does the geometry of the center spider make it manageable?
:S