Nick what printer are you using to make all your parts?
What kind of fill density, what polymer will you use on printed thread clamps?
Might this require nylon or polycarb?
Have you thought about heating up a blank thread clamp (No threads) -- then clamping around leadscrew.
You could heat up threaded rod then clamp (even with external clamp right at center)? Is this against the repRap rules?
:S
What kind of fill density, what polymer will you use on printed thread clamps?
Might this require nylon or polycarb?
Have you thought about heating up a blank thread clamp (No threads) -- then clamping around leadscrew.
You could heat up threaded rod then clamp (even with external clamp right at center)? Is this against the repRap rules?
:S