Your experience is exactly what I saw happening to mine in every aspect that you mentioned I have been at a standstill for over a week trying to figure it out my last iteration was to use ANDYs working profile and install that once i did that all my motion motors seemed to be operating as they should but may still be incorrect as I am not used to how the delta printers are supposed to move but I can controls movement form both the LCD and repetier.
The only thing in repetier that is acting funky is the hot end temp when I first power teh unit on I see the temp values for the extruder and the bed all is normal but if I reconnect or reset the boards when it comes back the extruder information has a new friend in the form of a string of numbers followed by the same data as listed for extruder 1 upon reset another new friend on and on. NO clue what is causing that.
The thing I am having trouble with is my extruder motor not matter what I do I can not get it to operate when I attach it to E0.
If I swapp the motor with the motor on Z it turns on and moves as the original z motor would so that tells me teh motor and the wiring to the motor is good
If I swap the polulu driver from say teh Y circuitry to the E0 circuitry the Y circuitry and motor still work fine so that tells me the polulu is fine E0 is still dead with the working polulu form Y
So it is pointing to the E0 circuitry or maybe some setting that is not set correctly that is stopping E) form working
The only thing in repetier that is acting funky is the hot end temp when I first power teh unit on I see the temp values for the extruder and the bed all is normal but if I reconnect or reset the boards when it comes back the extruder information has a new friend in the form of a string of numbers followed by the same data as listed for extruder 1 upon reset another new friend on and on. NO clue what is causing that.
The thing I am having trouble with is my extruder motor not matter what I do I can not get it to operate when I attach it to E0.
If I swapp the motor with the motor on Z it turns on and moves as the original z motor would so that tells me teh motor and the wiring to the motor is good
If I swap the polulu driver from say teh Y circuitry to the E0 circuitry the Y circuitry and motor still work fine so that tells me the polulu is fine E0 is still dead with the working polulu form Y
So it is pointing to the E0 circuitry or maybe some setting that is not set correctly that is stopping E) form working