Yes, I am working with repetier firmware and it looks good so far....After discovering the wrong microstepping jumpering on the board and solved it, went directly ahead with repetier firmware. I prefer this firmware because it works better with repetier host software.
Now I have solved the firmware issues, the host software configuration and the electronic issues, I still have one mechanical problem.
I couldnt built perfect diagonal rods, that are identical in length, because of the bad quality of my printed joints. I am still looking for assembled Rods with Traxxas Rod Ends and the correct length. Found them but in USA...not yet in Germany. So I will start calibrating, only after resolving this last problem.
Actual video of my build
Now I have solved the firmware issues, the host software configuration and the electronic issues, I still have one mechanical problem.
I couldnt built perfect diagonal rods, that are identical in length, because of the bad quality of my printed joints. I am still looking for assembled Rods with Traxxas Rod Ends and the correct length. Found them but in USA...not yet in Germany. So I will start calibrating, only after resolving this last problem.
Actual video of my build