I have assembled Mike's Delta-pi design and am using repeteir host with repeteir firmware. Mike would you be willing to please share your firmware? My electronics are Ramps 1.4. I am very new to this so I've been learning on the fly. I initially had problems wiring the motors but now I have everything wired correctly, since I can independently move all three motors in the correct directions. My problem though is that when I go to print something, the axes home and activate the endstops, but the carrariages then keep crashing into the endstops. The x-axis will come down, but then the x-axis motor will move slowly. My endstops have three wires and blink red when activated.
I'm using the RostockMax firmware from thingverse, which I have attached. I have held down each endstop while sending M119 command, and repeteir shows the endstops are activating by displaying the "H" next to the one being tested. Is there something I'm overlooking? I have set all feedrates, steprates, and accelerations to be equal. I aprreciate the help! Sorry if this has been covered before but I've tried searching threads to no avail.
I'm using the RostockMax firmware from thingverse, which I have attached. I have held down each endstop while sending M119 command, and repeteir shows the endstops are activating by displaying the "H" next to the one being tested. Is there something I'm overlooking? I have set all feedrates, steprates, and accelerations to be equal. I aprreciate the help! Sorry if this has been covered before but I've tried searching threads to no avail.