It's been a very busy few weeks at work. With the long holiday weekend, I finally had time to finish up the "final" version of my printer. I've gotten it printing, and it prints very well, so I've started to put together a series of blog posts on building the printer. I've just published the first in the series on building the 3DR "Simple" Delta printer: [trains.socha.com]
I spent quite a few hours on writing up this first post, so I'm going to take a break before I write the next post. In any event, here is what it looks like:
Some of you may notice there is a fan mount attached, but not fan. I need to go to the store and get a connector so I can extend the wires on my fan, as they're way to short now to reach the Printrboard. Also, this is a preliminary version of the fan mount--I plan to replace it with an improved version that will hold both the fan and an LED ring light.
-- John
I spent quite a few hours on writing up this first post, so I'm going to take a break before I write the next post. In any event, here is what it looks like:
Some of you may notice there is a fan mount attached, but not fan. I need to go to the store and get a connector so I can extend the wires on my fan, as they're way to short now to reach the Printrboard. Also, this is a preliminary version of the fan mount--I plan to replace it with an improved version that will hold both the fan and an LED ring light.
-- John