@brandonh: I agree with all that owens said. I would try a shoulder print and see how it goes. (If you still have concerns I can upload a modified version for vertical printing.) The angled cylindrical hole is actually better than a horizontal cylindrical hole. I got the beds custom water cut. PM me if you are in love with them I might have a few in my dinning room. (My wife loves me. I know she does.)
I use an MBE but, as owens mention, you can do better.
@nargos: I get the hot ends from QU-BD. The price I got was the bulk/friend discount. They sell them for $30 normally. See about the beds above.
@owens: I could make it narrower but I didn't want it to be so tight that it would be hard to tighten the M2 screw.
For now I am not going to change anything on the motor arm. For fun, here is a pic of how I could remove the bridging. I don't like it enough to put it in the repo. PM be if you want me to send you the 1.5MB file.
[attachment 22233 alternative.jpg]
I use an MBE but, as owens mention, you can do better.
@nargos: I get the hot ends from QU-BD. The price I got was the bulk/friend discount. They sell them for $30 normally. See about the beds above.
@owens: I could make it narrower but I didn't want it to be so tight that it would be hard to tighten the M2 screw.
For now I am not going to change anything on the motor arm. For fun, here is a pic of how I could remove the bridging. I don't like it enough to put it in the repo. PM be if you want me to send you the 1.5MB file.
[attachment 22233 alternative.jpg]