Quote
owens
Quote
nicholas.seward
@pjoyce42: You can print it in the orientation given. Most printers can bridge that far. It may sag but you have tons of layers until you get to the gear part so most printers will self-correct.
However, there is an untested version here. I am not sure if the tuner can be inserted. I think it can.
No issues at all putting the tuner in; there's plenty of clearance. I'm printing my third motor arm now. . .
Glad to hear that! Do you think the tuner would fit if the cutout was a 2d one that matched the other side? It's a minor aesthetic thing, but a symmetric design would look good.