Well with all the money I'll save drilling this in the basement, there's lots more left in the cookie jar for Torqspline.
I realize nobody has ever seen a 7/16 based version (yet) so this is a bit early in the process to be asking:
How tall could you make one of these before it's "to crazy tall" to be stable?
I'm ruling out anything over 6' simply based on not having a month or two to run prints. (:P) There's also not *that* much in the cookie jar....
If I'm doing the plywood my self, making the bottom board a bit larger would be pretty easy. I'm less concerned about "tip it over" stability than about "it was printing fine yesterday and now it's not" stability. Having the thing shake it's self to death on the first print probably also counts as "not stable".
I realize nobody has ever seen a 7/16 based version (yet) so this is a bit early in the process to be asking:
How tall could you make one of these before it's "to crazy tall" to be stable?
I'm ruling out anything over 6' simply based on not having a month or two to run prints. (:P) There's also not *that* much in the cookie jar....
If I'm doing the plywood my self, making the bottom board a bit larger would be pretty easy. I'm less concerned about "tip it over" stability than about "it was printing fine yesterday and now it's not" stability. Having the thing shake it's self to death on the first print probably also counts as "not stable".