Fixed the links!
When I went from normal to on its side the print had a 1mm shift. Upside down vs right side up are about the same so if you can quickly/gentry invert it during the infill you won't see much but a slightly larger layer in the middle. The 3/8" screws are springy enough to explain most of shift. The plastic and the joints should contribute to this a little. All in all I am impressed. It will be fun to compare this to when I have the 7/16" screws installed.
When I went from normal to on its side the print had a 1mm shift. Upside down vs right side up are about the same so if you can quickly/gentry invert it during the infill you won't see much but a slightly larger layer in the middle. The 3/8" screws are springy enough to explain most of shift. The plastic and the joints should contribute to this a little. All in all I am impressed. It will be fun to compare this to when I have the 7/16" screws installed.