Well, that's a lot better than what I get when I invert the Z axis on my i3 (which then falls to the floor more or less). :)-D:)-D
How fast were you printing on each print?
About the only other thing I can see to check in this vein is twist. Not quite sure how, but it would validate the PVC pipe / thread rod part of the design.
(yes I am sitting here looking at tube for my Franken-LISA).
How fast were you printing on each print?
About the only other thing I can see to check in this vein is twist. Not quite sure how, but it would validate the PVC pipe / thread rod part of the design.
(yes I am sitting here looking at tube for my Franken-LISA).
