Yesterday I have printed the first object with the 3DR. I started with 50 mm/s and used Repetier Host to increase the speed while printing. I wanted to see where the printer would fail...but it didn t...not after an increase to 300 % of the speed....Yes the speed had its impact on the quality but it was amazing to see how fast this machine could go...if the extruder was also so fast...and the best was, that thet test finished with success.
Without any "big" calibration efforts...Here is a first shot of the first object, it is the torture test you can download from the internet....
![postimg.org]( "postimg.org")
![postimg.org]( "postimg.org")
![postimg.org]( "postimg.org")
![postimg.org]( "postimg.org")
![postimg.org]( "postimg.org")
![postimg.org]( "postimg.org")
The first print...not perfect...but nothing to compare with the printers I have build until now. Talking about vibration, I don t know from where one could get them, there is nothing in this machine that could produce vibrations....A video would be helpful to visualize the problem.
Without any "big" calibration efforts...Here is a first shot of the first object, it is the torture test you can download from the internet....
The first print...not perfect...but nothing to compare with the printers I have build until now. Talking about vibration, I don t know from where one could get them, there is nothing in this machine that could produce vibrations....A video would be helpful to visualize the problem.
