Hopefully someone can help me out. Not sure what I'm doing wrong.
I'm using Slic3r to complie G-Code and I've tried both Richard's and Andy's version of the firmware.
Using Prointerface I can move x,y and z in the correct directions using the arrow interface on the left. The problem comes when I try to print. See the following video
[www.youtube.com]
In this I am trying to print the RepRap coin linked in second 4 of the guide. As you can see it wants to move my x all the way down. I'm not sure why this is but I have to stop the machine.
In Slic3r I have tried configuring it as was done in section 4 as well as defaults all around.
Anyone have any suggestions?
I'm using Slic3r to complie G-Code and I've tried both Richard's and Andy's version of the firmware.
Using Prointerface I can move x,y and z in the correct directions using the arrow interface on the left. The problem comes when I try to print. See the following video
[www.youtube.com]
In this I am trying to print the RepRap coin linked in second 4 of the guide. As you can see it wants to move my x all the way down. I'm not sure why this is but I have to stop the machine.
In Slic3r I have tried configuring it as was done in section 4 as well as defaults all around.
Anyone have any suggestions?