We would but there is a problem with your video....it is private, so no one can see it, please check your publishing settings.
>> I'm using Slic3r to complie G-Code and I've tried both Richard's and Andy's version of the firmware.
As you write, there is a firmware for Richard, for Andy, for me and for each one. There is no firmware for everyone. You have to tune your machine yourself.
Without looking to the video, this can t have something to do with the Slicer, no matters which slicer you are using.
Hope it helps.
>> I'm using Slic3r to complie G-Code and I've tried both Richard's and Andy's version of the firmware.
As you write, there is a firmware for Richard, for Andy, for me and for each one. There is no firmware for everyone. You have to tune your machine yourself.
Without looking to the video, this can t have something to do with the Slicer, no matters which slicer you are using.
Hope it helps.