Had fun printing the T800 model in black ABS at 0.2mm, however the bowden tube lag is rearing its ugly head. I can't get the cables to print properly because the filament is not starting and stopping in sync with the hotend movements. It ends up being a partial cylinder for the first few layers and then eventually gets knocked off and becomes a blob. Anybody have experience dealing with this type of issue? Retraction settings don't seem to help much on this... shorten the tube perhaps?
![GJ9A2228a.JPG]( "GJ9A2228a.JPG")
![GJ9A2227a.JPG]( "GJ9A2227a.JPG")
