What's the sequence for getting the updated firmware onto the Printrboard? I've got the latest version of Marlin with the necessary modifications, it compiles in the Arduino environment, then what?
I've updated the Printrboard with precompiled binaries from Printrbot before which required toggling a jumper pin on the Printrboard, then loading some software to upload the binary. Is that the sequence the same for this, I just point it at the newly compiled Marlin binary?
I've updated the Printrboard with precompiled binaries from Printrbot before which required toggling a jumper pin on the Printrboard, then loading some software to upload the binary. Is that the sequence the same for this, I just point it at the newly compiled Marlin binary?