Hi RickM, Hi garyhlucas , Hi vreihen,
thank you for your comments. I think it can be work for 12 Volt.
It is logical, that I have to wait a little bit more longer to get the Temperature.
Mainly I print PLA and if I try to Print ABS I think i have to wait.
For large objects PLA is better to print (temperature slim factor, I dont have the right word in my mind for this).
Sure you can design a Heatbed, who run on mains voltage (110/220 Volt).
There are a lot of solution, but I will Try it with the PiBot guys.
If they say me it can be work I think I have to try it :-) .
[reprap.org]
thank you for your comments. I think it can be work for 12 Volt.
It is logical, that I have to wait a little bit more longer to get the Temperature.
Mainly I print PLA and if I try to Print ABS I think i have to wait.
For large objects PLA is better to print (temperature slim factor, I dont have the right word in my mind for this).
Sure you can design a Heatbed, who run on mains voltage (110/220 Volt).
There are a lot of solution, but I will Try it with the PiBot guys.
If they say me it can be work I think I have to try it :-) .
[reprap.org]