Can someone please point me in the direction of information pertaining to the motor wiring? Which motors are the "x" "y" and "x". I realize it probably doesn't matter as long as the end-stops are right. I can just change the orientation of the printer to suit the wiring. I was more or less trying to wire it according to the established front already, though.
Also, does anyone have a source for a 170mm round heated bed? I found a 160mm kapton based heater at [www.ultibots.com]. I bought it to try out. I can't believe that the lack of 5mm worth of heat bed at the edges will hurt. I'll be using an aluminum heat spreader between the heater and the glass anyways.
EDIT:
found it finally on Rich's blog
Also, does anyone have a source for a 170mm round heated bed? I found a 160mm kapton based heater at [www.ultibots.com]. I bought it to try out. I can't believe that the lack of 5mm worth of heat bed at the edges will hurt. I'll be using an aluminum heat spreader between the heater and the glass anyways.
EDIT:
found it finally on Rich's blog
Quote
Before we dive into Firmware settings, do check your wiring, and make sure you have the X EndStop going to the X motor, Y EndStop going to Y and Z to Z. if you are unsure just be aware that you may need to check and swap them during the homing sequence. Especially if you see motors still running after it looks like they have hit the EndStop positions.
X = front left tower / Y = front right tower / Z = back middle tower