Yes i glued the the FSR with adhesive tape to bottom metal plate.
Also i glued with adhesive tape the M8 nut to the FSR.
If i pressed this FSR only between to flat plates they did not respond.
I dont know why. Maybe this FSR's have been a little bit special.
Maybe they only respond if the pressure is inside the outer 1mm Ring of this FSR's.
This outside Ring looks also a little bit higher then the inside of the fsr.
However. So it works very nice for me. I can aesy remove the Print Bed plate.
Exchange it maybe to some wooden plate for nylon in future. for better adhesive.
The plate is centered only between the 6 magetic standoffs.
So also the size of the print plate has not to be accurate.
Also i glued with adhesive tape the M8 nut to the FSR.
If i pressed this FSR only between to flat plates they did not respond.
I dont know why. Maybe this FSR's have been a little bit special.
Maybe they only respond if the pressure is inside the outer 1mm Ring of this FSR's.
This outside Ring looks also a little bit higher then the inside of the fsr.
However. So it works very nice for me. I can aesy remove the Print Bed plate.
Exchange it maybe to some wooden plate for nylon in future. for better adhesive.
The plate is centered only between the 6 magetic standoffs.
So also the size of the print plate has not to be accurate.