Wow guys! thanks for that feedback!
All very good ideas, especially, the idea about bad z tower position looks really good. I'm at work right now, so I can't look into more details. But I will do when I get home, and you've given me some good ideas to try out, and some measurements to make.
Regarding math, C and measuring capability, it should be no problem in theory... I have a home workshop, and I work as an electronic engineer doing hardware and some software also. BUT (there had to be a "but") I am also the proud father of a 2yr old and a 4 month old that keep me really busy.
About the fans... I have to run them low speed if I don't want them to blow me away ;-) Actually, they are not running in the first layers, so that did nothing in this print.
I'll keep you guys updated on the results.
All very good ideas, especially, the idea about bad z tower position looks really good. I'm at work right now, so I can't look into more details. But I will do when I get home, and you've given me some good ideas to try out, and some measurements to make.
Regarding math, C and measuring capability, it should be no problem in theory... I have a home workshop, and I work as an electronic engineer doing hardware and some software also. BUT (there had to be a "but") I am also the proud father of a 2yr old and a 4 month old that keep me really busy.
About the fans... I have to run them low speed if I don't want them to blow me away ;-) Actually, they are not running in the first layers, so that did nothing in this print.
I'll keep you guys updated on the results.