Quote
payala
so that did nothing in this print.
ah ok, I just thought it was the fan, cause I didn t find any other logical explanation for the fact that the printed filament has left the circle exactly there where the first fan (on the right side of the picture) is blowing and came back to the track after leaving the blowing zone of that fan.
When it arrives to the second fan, this does not happen, probably because that fan is not blowing towards the print surface but away from it. It is aspirating and not blowing. It means you planed to blow frish air with one fan and aspirate the hot air with the other. That s why we see the front side of one fan and the back side of the other one on the picture.
But since this is all not correct, I will wait and see. :-)
