Hi All
I've just published the latest iteration of my Cherry Pi printer, Cherry Pi II, on Thingiverse (http://www.thingiverse.com/thing:298168)
The major changes are :-
All electronics and PSU are now housed under the bed
Tower extrusions were reduced to 600mm to increase rigidity
Cross brace extrusions were reduced to 250mm
Delta rods were reduced to 200mm
Limit switches are now housed in the top printed apex pieces
Jhead mount re-designed to allow greater build height (270mm)
250mm diameter mirror used as print bed. 95mm print radius
Marlin firmware changed to Rich Cattell's fork
FSR Z probing installed
Printed T nuts used throughout (http://www.thingiverse.com/thing:28788)
Low friction spool mount
(http://www.thingiverse.com/thing:235925)
I'm looking at providing a complete kit of parts for anyone who is interested just PM me.
Andy
I've just published the latest iteration of my Cherry Pi printer, Cherry Pi II, on Thingiverse (http://www.thingiverse.com/thing:298168)
The major changes are :-
All electronics and PSU are now housed under the bed
Tower extrusions were reduced to 600mm to increase rigidity
Cross brace extrusions were reduced to 250mm
Delta rods were reduced to 200mm
Limit switches are now housed in the top printed apex pieces
Jhead mount re-designed to allow greater build height (270mm)
250mm diameter mirror used as print bed. 95mm print radius
Marlin firmware changed to Rich Cattell's fork
FSR Z probing installed
Printed T nuts used throughout (http://www.thingiverse.com/thing:28788)
Low friction spool mount
(http://www.thingiverse.com/thing:235925)
I'm looking at providing a complete kit of parts for anyone who is interested just PM me.
Andy