Andy,
Yep, you are right again. I'm using the following Sainsmart endstops and I just needed to choose one of the two GND wires in the middle to connect to my SIG and GND wires on the board.
Now I must figure out why my motors move way to harsh and far. The darn thing is going to vibrate off my table. Searching internet now...
Thanks again,
Mike
![4.jpg]( "4.jpg")
Yep, you are right again. I'm using the following Sainsmart endstops and I just needed to choose one of the two GND wires in the middle to connect to my SIG and GND wires on the board.
Now I must figure out why my motors move way to harsh and far. The darn thing is going to vibrate off my table. Searching internet now...
Thanks again,
Mike
