Hi Guys I have been tearing my hair out for the last couple of weeks. I have searched the web high and low, but cant find the answer.
I have calibrated my delta as per this recommended site [minow.blogspot.com.au] it appears to be recommended everywhere. I can get the printer to home correctly at A/B/C and center. But when I move around the bed it raises and lowers. opposite to the columns. I am using Repetier 0.91 configuration tool [www.repetier.com] and have played with a few error corrections and angle of columns. I can get slightly better results but still not getting there and I am just guessing. When I search on the web I get all sorts of info about formulators and spreadsheets but when I go to the blog he just talks about DELTA_RADIUS. I feel like I am missing something large in my entire setup.
If anyone could help I would really be grateful. Thanks Matt.
I have calibrated my delta as per this recommended site [minow.blogspot.com.au] it appears to be recommended everywhere. I can get the printer to home correctly at A/B/C and center. But when I move around the bed it raises and lowers. opposite to the columns. I am using Repetier 0.91 configuration tool [www.repetier.com] and have played with a few error corrections and angle of columns. I can get slightly better results but still not getting there and I am just guessing. When I search on the web I get all sorts of info about formulators and spreadsheets but when I go to the blog he just talks about DELTA_RADIUS. I feel like I am missing something large in my entire setup.
If anyone could help I would really be grateful. Thanks Matt.