Woohoo... almost done.
But I'm having two problemes;
G30 work, but it "slam" into the bed... so much that a motor may skip steps, so when it begin calibration, he's not in the middle.
Speaking of calibration... I need to lower the "BED_DIAMETER" to 40, else my arms are disconnecting. What wrong I did ? The magnet hold pretty strong, they seems to disconnect at angle (when one axis is moving to far).
Picture btw...
![4lLPbKn.jpg]( "4lLPbKn.jpg")
But I'm having two problemes;
G30 work, but it "slam" into the bed... so much that a motor may skip steps, so when it begin calibration, he's not in the middle.
Speaking of calibration... I need to lower the "BED_DIAMETER" to 40, else my arms are disconnecting. What wrong I did ? The magnet hold pretty strong, they seems to disconnect at angle (when one axis is moving to far).
Picture btw...
