Hi again,
Sorry , i searched on internet and everything but i didn't find an answer ,
Now everything is ok with my firmware but when i use the G30 A command i have a motor (i guess that it is only one ) that skip steps during the calibration.
I can hear a click noise ant it is every time at the same place on the bed. I checked the tension of the belts and tried to modify the current on the stepper drivers but it still does the same a the same emplacement.
I even changed the stepper driver and nothing changes.
Do you know what i can do ?
Because with that the calibration goes wrong :s
thank you,
Canaylan
Sorry , i searched on internet and everything but i didn't find an answer ,
Now everything is ok with my firmware but when i use the G30 A command i have a motor (i guess that it is only one ) that skip steps during the calibration.
I can hear a click noise ant it is every time at the same place on the bed. I checked the tension of the belts and tried to modify the current on the stepper drivers but it still does the same a the same emplacement.
I even changed the stepper driver and nothing changes.
Do you know what i can do ?
Because with that the calibration goes wrong :s
thank you,
Canaylan