Thanx for answers!
"The knock of death", yeah, really hate that sound, can hear it from another room when it happens, though its usually because of to low temperature in my case.
But it doesn't looks like its dropping in temp anywhere.
I ran a print last night and looked at it this morning and noticed something, at first print i thought it was the settings that made the print smaller because it didn't think it had the space to print, but take a look at these pictures.
Left side: [www.silfhyttan.se]
Right side: [www.silfhyttan.se]
And whats most interesting, the bottom: [www.silfhyttan.se]
The lines are not straight...
But its only on the right side...
Is one of my motors slower ?
///M
"The knock of death", yeah, really hate that sound, can hear it from another room when it happens, though its usually because of to low temperature in my case.
But it doesn't looks like its dropping in temp anywhere.
I ran a print last night and looked at it this morning and noticed something, at first print i thought it was the settings that made the print smaller because it didn't think it had the space to print, but take a look at these pictures.
Left side: [www.silfhyttan.se]
Right side: [www.silfhyttan.se]
And whats most interesting, the bottom: [www.silfhyttan.se]
The lines are not straight...
But its only on the right side...
Is one of my motors slower ?
///M