Thats what I ended up doing... pressed in the "balls" and used springs - so far so good!
![20140815_183940_zps4f90c16a.jpg]( "20140815_183940_zps4f90c16a.jpg")
![20140815_183949_zps44800940.jpg]( "20140815_183949_zps44800940.jpg")
![20140815_183958_zps54c66c1d.jpg]( "20140815_183958_zps54c66c1d.jpg")
What about the all aluminum ones Ive seen? Would these be a better and tighter solution?
![RC_accessories_metal_ball_link_metal_ball_joint_634661609805857545_1.jpg]( "RC_accessories_metal_ball_link_metal_ball_joint_634661609805857545_1.jpg")
What about the all aluminum ones Ive seen? Would these be a better and tighter solution?
