Re: Cherry Pi III Is Available

Quote
nka
Found a mirror to get me back on track, I'm calibrating right now. Hope people didnt think I was buying those to decorate, they are ugly... lol

Yesterday, I was looking at heatbed and I think the 220mm (180mm heated) heatbed used for the Orion could work very nicely (with some braket to hold it) : [seemecnc.com] . I might go this way if I dont go with the custom one.



I also got a question. I'm using the firmware for the Mini Kossel from Rich Cattell you provided me.

I was following this tutorial ( [www.youtube.com] ) to do a pre-calibration using M666.

I was ajusting the tower "X" at X-73.6 Y-42.5, I found that I touched the bed at 1.2mm, so I did "M666 X1.2", "G28" then "G0 X-73.6 Y-42.5" and used the Repetier-Host (also tried with the Pronterface) and I was touching the bed a 1.2 agains... I did this like 4 time, (I was at M666 X4.8) and I was still touching the bed at 1.2.

So I tried M500 and a reload... same thing.

It seems to be the same thing with the "M666 Hxxx". I was scraping the tape, so I removed some height and it was still scraping it... like it dosent use those? I Even tried "M666 H100" to see what would happen... and notthing. My max height is like 238.3 and I setted 240 into the firmware. Tried the same thing after a M502, M500 and reset of the printer.

What I was doing wrong? I'm lost.

I'm auto calibrating right now with the "G30 A", I'll tried to see if it does a better calibration than me! :(