Quote
vreihen
Quote
maso
[attachment 36189 fanfit.jpg]
I can also confirm that the fan will work when it's that close to the magnet. Spins like a dream!
I am using 1/2 inch (12.7mm) spherical magnets, and just discovered that my E3Dv5 fan motor does *not* spin without a manual nudge with my finger to get it rotating. Even then, it only seems to be spinning at quarter of the speed it normally would.
Me thinks it's time to look at the non-magnetic setup again.....
Hi Arthur
If you rotate the magnets you will find a 'sweet spot' where they don't cause this issue. I had the same problem on the original Cherry Pi.
Andy