Awww... must be that. Mine came from AliExpress, might be cheap. I should have ordered those from Openbuild at the same time of the mini wheel.
btw, I fixed the problem, I just placed a small paper clip part between them !
I just have to figure out one problem. Sometime, I have wierd stuff on my print. Like there's a "hole" on a section, like if the extrusion stopped at this place or did the layer too low or too high...
I also have miss alignement at some place, it sound like it's when the layer begin, maybe the nozzle "kick" a little too far. Maybe my belt suck and I have backlasth (I dont know how to spell that?).
btw, I fixed the problem, I just placed a small paper clip part between them !
I just have to figure out one problem. Sometime, I have wierd stuff on my print. Like there's a "hole" on a section, like if the extrusion stopped at this place or did the layer too low or too high...
I also have miss alignement at some place, it sound like it's when the layer begin, maybe the nozzle "kick" a little too far. Maybe my belt suck and I have backlasth (I dont know how to spell that?).
