Re: Strange behaviour of G29 command

Thank you for the answer. I have been looking into Marlin_main.cpp for a couple of days days now and I had the same suspect. then I did try the firmware you are linking, it's kind of working but i have to hook up the FSR output to the bed thermistor pin, which I would rather not, because with the ZMIN pin works just fine... now I have a working setup to experiment... I'll try to figure out if I have any improvement over the manual levelling and decide if I want to keep it or not....
I thing I'll keep this setup until the main MARLIN firmware incorporates the support for autoleveling on deltas.


Thanks
A,