Re: Strange behaviour of G29 command
Thank you for the answer. I have been looking into Marlin_main.cpp for a couple of days days now and I had the same suspect. then I did try the firmware you are linking, it's kind of working but i...
View ArticleExtruder direction only forward
Extruder motor is running in the right direction but when I let go of his reverse so still running only forward. Can someone help me please
View ArticleRe: Which grease on the rods ?
I am using generic valvoline high temperature synthetic grease. Its designed to pack automotive bearings. It also has a very high burning temp, 400F+. I have a tub of the stuff I keep for automotive...
View ArticleRostock Max vs Kossel Mini belt system
Is it worth the increased design complexity and cost to run the belt in the channels compared to the kossel minis exposed belt system?
View ArticleEnd Stop Woes... Homing issues.
Hello everyone, I am having a bit of trouble getting my end stops to work under repetier firmware and I am starting to run out of ideas. Here is what I have: Delta printer setup of my own relative...
View ArticleClik here to view.
End stop polarity ?
My Rostock came with mechanical endstops: endstop.JPG The building instruction warns me on polarity on the Ramps. i do not understand, it is a make/break switch. How can reversing the wires be any...
View ArticleRe: End Stop Woes... Homing issues.
Couple things to add: 16AWG was too thick for the terminals, needed to use 18AWG... I am using the M119 Gcode command in repetier host to test the signals of the end stops and I am infact getting the...
View ArticleRe: End Stop Woes... Homing issues.
So I think I have it figured out. Once i placed the endstops on the max pins (which was quite an ordeal, I had to steal some connectors off of some fans i have), it seems to work now. I still have to...
View ArticleRe: End stop polarity ?
https://groups.google.com/forum/#!topic/makergear/4OTkvvvfqws QuotePolarity of the switch doesn't matter. However, the RAMPS has three pins for each end-stop (to support optical end-stops). So you...
View ArticleRe: End Stop Woes... Homing issues.
https://groups.google.com/forum/#!topic/deltabot/k10ernLi7LU QuoteIf you're wiring your endstops into the X3's min connectors, the nice locking ones, you'll need to change the pin assignments in...
View ArticleRe: Strange behaviour of G29 command
Use Rich Cattell's software. It offers auto calibration, auto bed levelling and a very enhanced M666 functionality. [github.com] [groups.google.com] Andy
View ArticleRe: Rostock Max vs Kossel Mini belt system
As someone who *hates* exposed belts for both safety and aesthetic reasons, I vote yes..... :)
View ArticleRe: End Stop Woes... Homing issues.
Repetier's web-based config builder prompts for what pins should be used on each endstop:
View ArticleRe: Yet another slicing software thread?
Love Cura. I went back to Slic3r for a trial print, and it killed me how long the slicing was (I waited almost 10 minutes before I just bailed). Same design sliced in Cura in < 10 seconds. Repetier...
View ArticleRe: Curious delta problem: slanted prints
I'd be willing to try your Gcode to see if my printer does the same thing. I'm running a Marlin FW that supports FSRs, and have the RAMPs board too. Would be at least another data point if nothing...
View Article