So I think I have it figured out. Once i placed the endstops on the max pins (which was quite an ordeal, I had to steal some connectors off of some fans i have), it seems to work now. I still have to hook everything back up to the real printer and test again. But things are looking better.
Which leads me to a new question. Is there any way in configuration.h or in the host software to let the printer know that it wants to check the min pins for homing? I assume that I could rework things in pins.h to make this work if not.
Which leads me to a new question. Is there any way in configuration.h or in the host software to let the printer know that it wants to check the min pins for homing? I assume that I could rework things in pins.h to make this work if not.
