Quote
pugzor
Nice! Yeah, that's what I was thinking too vreihen. [www.jaycar.com.au] Think I might build it with a hard-wired mains cord to begin with, but once I can print out some parts, I'll make a nice little add-on box to mount an IEC connector onto.
Andy, do you think there'd be enough belt in the quoted "4 metres" to add that extra 50mm of height? I got my V Slot today and I just want to make sure before I cut, haha. I'm not too worried if I don't, I'd prefer to build with a lower build height than have to acquire more GT2 belt at this stage!
Hi Andrew
For the standard build with 600mm tower extrusions I cut my belts to 1220mm so if you go to 650mm towers you need to cut three at 1320mm. So yes, you should get all three from a 4M roll of GT2.
Andy