Re: Want to do a "pencil" dry print, but will not do x and y movements after the carrage is lowered to z = 0

Thank you for the responses.
I've since updated my marlin and now my configuration file is represented as this dropbox link:

[www.dropbox.com]

To 3D-ES, Thx for your reply!

It makes sense what you say about the waiting time, I'm guessing the duration of the wait
is determined by TEMP_RESIDENCY_TIME - 10 for me.

I've inputted M302 as per your suggestion, but I've noticed it doesn't give an Echo callback after on Prointerface so I didn't know if it was doing something,
I tried printing after, but it still stalls saying W:?

This Marlin config now has disabled the ENABLE_AUTO_BED_LEVELING, and Z_MIN endstop is now not reported after the M119 command is called.

I tried setting the hotend nozzle temperature (although I don't have one connected) to the ambient temperature, as seen in this screenshot:
[www.dropbox.com]
It didn't presume a dry print, even though they're both virtually the same.


To Replace, Thx for your reply!

I've tried the "dry print" option in the manual section of Repetier host, to no avail.

This is the screenshot of the situation:
[www.dropbox.com]

Additionally, I've set EXTRUDE_MINTEMP to 1 to ensure that I'm not under-temperature (and it's not winter haha).

Still stumped
DennyP