My Rostock Delta Mini Pro instructions expect me to lay the geared extruder motor under the machine and have the bowden tube make a large circle loop.
however, it looks that the stiffness of the bowden tube will move the hot-end plate out of the horizontal pane, while travelling. Not sure if it will affect printing. I am not that far yet.
Also, putting the motor on top, will give tension at the tube's routing.
What is the best way to set this up ? How keep the tube as vertical as possible above the hotend during travel ?
Pictures ?
thnks Thomas
however, it looks that the stiffness of the bowden tube will move the hot-end plate out of the horizontal pane, while travelling. Not sure if it will affect printing. I am not that far yet.
Also, putting the motor on top, will give tension at the tube's routing.
What is the best way to set this up ? How keep the tube as vertical as possible above the hotend during travel ?
Pictures ?
thnks Thomas