Hmm, I am digging through my config and don't exactly remember what I did...
It could be one of these things:
My printer has no nozzle probe, it is disabled by setting Z_MIN_PIN to -1
I also commented ENABLE_AUTO_BED_LEVELING out by adding //
I have changed min_software_endstops and max_software_endstops to false,
this is probably not a good idea, I will restore that setting and see what happens.
My printer runs Johann C. Rocholl's deltabot version
Perhaps your problem has been fixed in his repository?
My version of Configuration.h is attached, hope it helps!
It could be one of these things:
My printer has no nozzle probe, it is disabled by setting Z_MIN_PIN to -1
I also commented ENABLE_AUTO_BED_LEVELING out by adding //
I have changed min_software_endstops and max_software_endstops to false,
this is probably not a good idea, I will restore that setting and see what happens.
My printer runs Johann C. Rocholl's deltabot version
Perhaps your problem has been fixed in his repository?
My version of Configuration.h is attached, hope it helps!