Okay,
I got the Serial Monitor to work and tried the commands.
I think you mean G28 rather than M28.
But the key part, G1 Z200:
The Serial Monitor reports back: ok
but the printer FAILS to move.
Sooo, either Hardware or Firmware...
Both of which I have no idea how to find out which one is causing the issue.
I got the Serial Monitor to work and tried the commands.
I think you mean G28 rather than M28.
But the key part, G1 Z200:
The Serial Monitor reports back: ok
but the printer FAILS to move.
Sooo, either Hardware or Firmware...
Both of which I have no idea how to find out which one is causing the issue.