Quantcast
Channel: Reprap Forum - Delta Machines
Viewing all articles
Browse latest Browse all 20291

Re: Cherry Pi III Is Available

$
0
0
Quote
maso
I did find that I had to tighten those carriages down quite a bit. Come to think of it, I had to shave some plastic out of the slot in one of them so that I could get it tight enough.

But it really wasn't too bad. And the printer is working swell now. Maybe one of us should try to make a carriage that has the wheels closer together sometime.

Honestly, mine are far enough apart that I will have to design another wheel section of the carriage. I've just dry attached the wheels and it's enough that if I put the two wheels on the same side into the V slot, the bottom of the wheel on the other side is flush with the outer surface of the extrusion. :( Hmm, now I need to find a local printer who'll produce it for me.

Viewing all articles
Browse latest Browse all 20291

Trending Articles



<script src="https://jsc.adskeeper.com/r/s/rssing.com.1596347.js" async> </script>