Hi
I have a reprap rostock 3d printer and I have been trying to configure it.
I am having issues using pronterface. The problem I am having is that when I hit the "home" it does not move all the axis to the endstops. Instead it makes a high pitched hum for a few seconds then if you try to lower it it will, but if you try to raise it will not go past that point that it was at when you hit home. It seems like it is establishing home instead of going to the endstops.
What should I do to fix this problem.
Thanks
Tanner
I have a reprap rostock 3d printer and I have been trying to configure it.
I am having issues using pronterface. The problem I am having is that when I hit the "home" it does not move all the axis to the endstops. Instead it makes a high pitched hum for a few seconds then if you try to lower it it will, but if you try to raise it will not go past that point that it was at when you hit home. It seems like it is establishing home instead of going to the endstops.
What should I do to fix this problem.
Thanks
Tanner