Andy,
Thanks for the updates to the carriages! I was looking at the V-Wheel carriage design, both the OpenBuild .stl and the original .skp file, and had a question.
I was wondering what you use to tighten the carriage down onto the v-slot?
The earlier design from Thingiverse has a place for a captive nut, but i just see a shallow slot in these new ones. Does that serve a purpose? Or are you just tapping the plastic and relying on the strength of the threads in the plastic there?
Thanks for the updates to the carriages! I was looking at the V-Wheel carriage design, both the OpenBuild .stl and the original .skp file, and had a question.
I was wondering what you use to tighten the carriage down onto the v-slot?
The earlier design from Thingiverse has a place for a captive nut, but i just see a shallow slot in these new ones. Does that serve a purpose? Or are you just tapping the plastic and relying on the strength of the threads in the plastic there?