I fixed the problem with the printer not homing.
The HOMING_FEEDRATE in congiguration h was set to high, it was set to 200*60 for each axis, this is 12000.
I set the homing feedrate to 200 and it homed the printer just as it should, I am still experimenting with the speed of the printer but for now 200mm/s works fine.
Thanks for you help
Tanner
The HOMING_FEEDRATE in congiguration h was set to high, it was set to 200*60 for each axis, this is 12000.
I set the homing feedrate to 200 and it homed the printer just as it should, I am still experimenting with the speed of the printer but for now 200mm/s works fine.
Thanks for you help
Tanner