Hi !
Me again :)
I've rebuilt the whole thing with magnetjoints... but used to weak magnets so i went back to my original design in wait for stronger magnets...
I loosened the plasticjoints and now it moves really fine, even on the outer regions, have not calibrated the steppers yet though...
But...
I am currently printing a big box, 165x150mm and 100mm high.
As i said in my first post... the speeds are slower on the outer regions, but the filament comes out at the same pace so it kinda floods, small bumps because of to much filament pushed through.
I would like the motor to run a little faster when it comes closer to the end of the print bed, but it doesnt, same pace everywhere.
Anybody have this phenomenon ?
Me again :)
I've rebuilt the whole thing with magnetjoints... but used to weak magnets so i went back to my original design in wait for stronger magnets...
I loosened the plasticjoints and now it moves really fine, even on the outer regions, have not calibrated the steppers yet though...
But...
I am currently printing a big box, 165x150mm and 100mm high.
As i said in my first post... the speeds are slower on the outer regions, but the filament comes out at the same pace so it kinda floods, small bumps because of to much filament pushed through.
I would like the motor to run a little faster when it comes closer to the end of the print bed, but it doesnt, same pace everywhere.
Anybody have this phenomenon ?