Hi
I have been trying to get my Reprap Rostock printer going and I ran into an issue and I was wondering what I need to do to fix it.
When I use the commands to move the printer in the horizontal directions it does not move level, it rises as it moves farther in the x and y axis. I was wondering what I need to adjust to fix this issue?
Another question I had was the setting for the distance for the z home position with the calculated steps per millimeter is smaller than I measured,it takes a setting of 51.15 when the actual hight is 81.5cm, will this cause problems in the scale of the prints? Should the z home position setting be in mm because that is what the rest of the program seems to use for units?
I have 20 teeth pulleys, GT2 belts, 200 step nema 17 steppers, and 1/16 step pololu drivers. The setting I have for the xyz steps is 80.0
Thanks
Tanner
I have been trying to get my Reprap Rostock printer going and I ran into an issue and I was wondering what I need to do to fix it.
When I use the commands to move the printer in the horizontal directions it does not move level, it rises as it moves farther in the x and y axis. I was wondering what I need to adjust to fix this issue?
Another question I had was the setting for the distance for the z home position with the calculated steps per millimeter is smaller than I measured,it takes a setting of 51.15 when the actual hight is 81.5cm, will this cause problems in the scale of the prints? Should the z home position setting be in mm because that is what the rest of the program seems to use for units?
I have 20 teeth pulleys, GT2 belts, 200 step nema 17 steppers, and 1/16 step pololu drivers. The setting I have for the xyz steps is 80.0
Thanks
Tanner