Edit: this is more intended to address @alexella's point than to suggest that you change up your whole setup, @jaguarking11.
I haven't tried it with my own setup, but I remember it used to be popular to demonstrate delta printers working sideways and upside down.
What if you inverted your printer, placing the bed up where the heat would be?
It might be more hassle than it's worth, but it might save some trouble in other ways.
I haven't tried it with my own setup, but I remember it used to be popular to demonstrate delta printers working sideways and upside down.
What if you inverted your printer, placing the bed up where the heat would be?
It might be more hassle than it's worth, but it might save some trouble in other ways.